Rolling and bending services of metal are available in Singapore

Rolling plates is one of the procedures involved in producing metal and is regarded as one of the more complex operations. Even if you change one of the variables, it will have an impact that is direct on a good number of the others. When determining the parameters for a plate roll, it is vital to consider the factors of the material, in addition to its chemical make-up and work-hardening properties.

Looking for rolling and bending services? Check out Pollisum today. Plate rolling machines at Pollisumcan roll plates with plate thicknesses, plate lengths, and plate radii of curvature. The oil and gas industry, the maritime industry, and the construction industry will all be able to profit from the high-quality plate bending services that will be given by the firm specializing in fabrication and logistics.

Bending and rolling of metal plates have comprehensive utilization in many industries

The kinds of materials that bending machines can bend include, a wide variety of plates that are of steel, including stainless, mild and carbon steel, as well as angle bars and c-channels, amongst other sorts of materials.

In the sector of the manufacturing industry that is responsible for rolling steel plates, the question of whether or not the raw material, which is referred to as the steel blank, should be trimmed before the rolling process or whether or not it should be provided with excess material that can be trimmed during and after the rolling process arises quite frequently.

Rolling and bending services

Pollisum provides the best in class bending and rolling in Singapore

Regarding the size of the blank, there is also the issue of whether or not the plate that is going to be rolled may be cut with the beveled ends. If it is possible to bend the plate ends before the rolling process starts, then the answer is that there is no need for any more material to be used. Bending is the term that’s used to describe this movement. The first phase in the bending process may be carried out using either a press brake fitted with a radius die or a plate roll consisting of three rolls. The amount of pressure determines the most significant thickness of a plate that may be bent that the top roll of the machine can exert to its total capacity.

The capacity of a rolling machine may be defined by the combination of the most considerable thickness and the lowest radius that the machine can bend into a specific plate size. The maximum width of the plate is another factor that must be considered.